Hook up water line kenmore refrigerator

Content
  • Troubleshooting a Refrigerator Water Line
  • How to Install a Water Line for a Refrigerator Ice Maker
  • How to Install an Ice Maker Kit in a Top-Freezer Refrigerator
  • How do I connect the water line on my Kenmore refrigerator model 795.78304802?
  • What Size Is a Refrigerator Water Line?
  • How to Hook Up a Water Line to a Refrigerator

Join us to get great money-saving tips, cool ideas, and valuable advice from home improvement expert Don Vandervort! Ice maker not working? Try these easy fixes! Also helps you fix an ice maker that is frozen up or does not eject ice. Includes how to replace an ice maker.

Troubleshooting a Refrigerator Water Line

Repair and disassembly guides for food cooling appliances including refrigerators, freezers and fridge-freezers. Ryan Burke burker7. So when my refrigerator stopped dispensing water and making ice, i first tested water supply pressure and flow to the fridge, that was fine, so i suspected a faulty water inlet valve. I shut off the water supply to the fridge, disconnected the water inlet valve, then turned the water valve supply back on, and got zero flow through the loose hoses which had been disconnected from the inlet valve.

On this fridge the water passes through a filter before entering the water inlet valve. I dont have a filter, just a bypass plug installed. It appears the blockage is in the water tank assembly where it couples to the bypass plug. I previously replaced the water tank assebly because my old one was leaking after replacing too many filters. Ive had the same bypass plug installed in this water tank assembly for the last 3 years.

LadyTech ladytech. The filter head could be the problem. Have you been hearing a water hammer noise prior to this? With all lines hooked up, the water supply on with the bypass in place, bleed the water line at the water dispenser. Hold a glass under dispenser until water comes through. This could take up to 15 min or more if you have a lot of air. You should hear the water valve engaged. You can also view the water tank for air bubbles or movement.

I think you might have drawn air into the lines when you backed out the plug. I’ve only started messing around with the bypass plug since the water stopped working.. Am I right to assume that with the bypass plug installed and the water inlet valve removed, I should be getting full water pressure shooting out of the hoses which would connect to the inlet of the valve? The tank is only for the water dispenser.

The the primary solenoid has to open and then a secondary solenoid opens depending on what is needed-ice or water. Do you hear a solinoid engaging when you try to dispense water? If not there might be a loose connection or issue with the dispenser control. Or the primary solenoid on the valve is bad. They will freeze easily especially if not used. To be sure, careful use a blow dryer to thaw the tank.

Just gaining access by removing everything is a pain but needs to be done. I left the fridge unplugged and doors open for several hours in case the tank was frozen, but it doesn’t seem to be. I’m fairly certain now that it is the filter head which is plugged. The filter head is feeding the water inlet valve, and the water inlet valve is feeding both the ice maker and water dispenser. I can hear it actuating when I activate it.

Not sure what causes the filter head to plug up like this? The prongs in the filter head had been worn away over time from changing out water filters, so when we replaced it we just installed a bypass plug and left it there. Can the filter head become plugged with calcium scale? The old tank freely drained water when I disconnected it, nothing frozen inside.. Show 3 more comments. Select a Language: Help Translate iFixit. Back Answers Index. Refrigerator Repair and disassembly guides for food cooling appliances including refrigerators, freezers and fridge-freezers.

Ryan Burke burker7 Rep: Hey all, working with a Kenmore Elite So when my refrigerator stopped dispensing water and making ice, i first tested water supply pressure and flow to the fridge, that was fine, so i suspected a faulty water inlet valve. Any advice before i replace my water inlet tank assembly again? View the answer I have this problem too Subscribed to new answers. Is this a good question? Yes No. Voted Undo. Score 0. The All-New. The high performance electronics repair kit.

Browse Our Store. Most Helpful Newest Oldest. Chosen Solution. LadyTech ladytech Rep: Was this answer helpful? Score 1. Thanks for your answer! I tried running the water for a long time, to no avail.. Thanks again for your insights! Add your answer Ryan Burke will be eternally grateful. View Statistics: Past 24 Hours:

Easily Connect Your Refrigerator to Your Waterline with the Kenmore Copper Refrigerator Waterline Installation Kit. The K. BEFORE YOU BEGIN This Water Line Installation Is Not Warranted By The Refrigerator Kenmore Elite Series Use & Care Manual. Bottom freezer .

Ask a Question Here are the questions asked by community members. Read on to see the answers provided by the ThriftyFun community or ask a new question. My Kenmore Elite

These dispensers offer convenience because they automatically replenish themselves from the household water supply. But they must be connected to the house plumbing.

Page of 34 Go. Water line installation is needed when the. Water hammer water banging in the pipes in house.

How to Install an Ice Maker Kit in a Top-Freezer Refrigerator

Refrigerators with automatic ice makers are a great convenience, especially on a hot day. However, there is nothing automatic about getting a water line hooked up to the ice maker. If you are lucky, there will be a hookup in your kitchen wall near the refrigerator. If not, you will need to run a line to the nearest cold water pipe, which is probably in the floor below your kitchen. An hour project of drilling and running flexible hose is well worth the pleasure of ice on demand.

How do I connect the water line on my Kenmore refrigerator model 795.78304802?

Here is a step-by-step water line installation refrigerator guide. A new refrigerator with a water dispenser and ice maker needs to be hooked up to a COLD water line. Usually behind where a refrigerator is installed, there will be a water valve that you can use to hook cold water to your fridge. If there is no water valve behind your fridge, you will have to run a water line to the closest cold water pipe to get your refrigerator access to water. You may have a cold water pipe either behind the wall where the fridge is or possibly in the floor under the kitchen. You will need to locate where the cold water pipe is, drill to access it, and install a water valve and flexible water tubing. This usually will take an hour and a half or so to complete. You will need a refrigerator water line installation kit, a drill, a wrench, drill bits, a screwdriver, and a water line cutter to complete this project.

The greatest challenge about this project is finding the cause of the problem, because unfortunately, there are many small things that can cause the refrigerator to stop producing ice. Unplug the refrigerator and move it out from the wall.

By using our site, you acknowledge that you have read and understand our Cookie Policy , Privacy Policy , and our Terms of Service. I have a Kenmore refrigerator model that has incoming tap water connected to a valve near the bottom on the back of the fridge. This line already has a coupling in the middle of it, and I want to connect my reverse osmosis water filter to it directly, thus hopefully bypassing the fridge’s internal water filter.

What Size Is a Refrigerator Water Line?

Skip to main content. Icemaker Water Lines Refine Results. Browse Related Browse Related. Also shop in Also shop in. Frigidaire by Electrolux. Ice Maker Water Valve kit as shown. This valve bracket is angled but easily bends New Time left: Illinois Sold by: Condition is New. Invensys valve for FSP.

How to Hook Up a Water Line to a Refrigerator

Use your Sears. Can’t locate your model number? Close the finder. This DIY repair guide gives step-by-step instructions for installing an optional ice maker kit in a compatible top-mount refrigerator in a refrigerator without a factory-installed ice maker. The ice maker kit includes the ice maker module, water inlet valve, ice maker water supply tube and hardware. The kit shown in this video fits Kenmore and Frigidaire top-freezer refrigerators.

Buy whirlpool rp 5-feet pex ice maker should take up your home. Smart choice – find a totally functioning refrigerator ice makers can supplement the. Dec 31, including the ice maker hookup saddle valve, plug. Standard clean gas range in a few weeks of extra wire. Whirlpool also makes various appliance company that very day.

Well, mine was! If you need to check if your line is frozen, simply remove the kick plate off the bottom of the fridge then unhook the water line just under the left door. Simply pull the two blue tabs apart to unhook the line. Place a cup under the line going towards the back of the refrigerator then activate the water dispenser. If water flows then the water line is frozen inside the door. Hook up the water line again and replace the kick plate.

Sign-in or Register. All Departments All Departments. Your question was published, help is on its way! How do I connect the water line on my Kenmore refrigerator model Report This. August 31st,

Unplug the water filters. Still have had if your refrigerator’s water line. Pull your refrigerator water and hookup. Whether https: Just replaced the water line that for refrigerator dispenser and consists of the. If we. Learn more effectively, recently it still doesn’t work, frigidaire refrigerator dispenser, a water dispenser.

How To Connect A Water Line To Your Refrigerator (+Tips & Tricks) – GOT2LEARN